Publicidad
Idiomas disponibles
Idiomas disponibles
en-us Service settings
To be able to use Home Connect®, you must first set up
the connection to the WLAN home network (Wi-Fi
the Home Connect® app.
After switching on the appliance, wait at least 2 minutes
until internal device initialization is complete. Only then
should you set up Home Connect®.
The Home Connect® app guides you through the entire
registration process. Follow the instructions in the
Home Connect® app to implement the settings.
Tip: Follow the instructions in the Home Connect® app as
well.
Notes
Also note the safety information in this instruction
¡
manual and ensure that it is also observed when
operating the appliance using the Home Connect® app.
→ "Safety", Page 4
Operating the appliance on the appliance itself always
¡
takes priority. It is not possible to operate the appliance
using the Home Connect® app during this time.
12.1 Setting up the Home Connect® app
Install the Home Connect® app on your mobile device.
1.
Start the Home Connect® app and set up access for
2.
Home Connect®.
The Home Connect® app guides you through the entire
registration process.
12.2 Setting up Home Connect®
Requirements
The Home Connect® app is installed on your mobile
¡
device.
The appliance receives signals from the WLAN home
¡
network (Wi-Fi) at its installation location.
Open the Home Connect® app and scan the following
1.
QR code.
Follow the instructions in the Home Connect® app.
2.
Wi-Fi is a registered trade mark of the Wi-Fi Alliance.
1
18
12.3 Remote diagnostics
) and to
1
The Customer Service can access your appliance via
Remote Diagnostics if you ask them to do so, if your
appliance is connected to the Home Connect® server and
if Remote Diagnostics is available in the country where
you are using the appliance.
Tip: Further information and details about the availability
of Remote Diagnostics in your country can be found in the
Service/Support section of your local website: www.home-
connect.com.
12.4 Data Protection
See the information on data protection.
The first time your appliance is registered on a home
network connected to the Internet, your appliance
transmits the following types of data to the
Home Connect® server (initial registration):
Unique appliance identification (consisting of appliance
¡
codes as well as the MAC address of the installed Wi-Fi
communication module).
Security certificate of the Wi-Fi communication module
¡
(to ensure a secure data connection).
The current software and hardware version of your
¡
home appliance.
Status of any previous reset to factory settings.
¡
This initial registration prepares the Home Connect®
functions for use and is only required when you want to
use the Home Connect® functions for the first time.
Notes
Please note that the Home Connect® functions can only
¡
be used in conjunction with the Home Connect® app.
Information on data protection can be retrieved in the
Home Connect® app.
It is possible that users, persons or spaces outside of
¡
the appliance may be captured by the cameras and
therefore displayed in the Home Connect® app. Such
photos are processed in the Home Connect® system
for the purpose of provision in the Home Connect® app.
Information on data processing can be retrieved in the
Home Connect® app.
13 Service settings
Se r v i c e s e t t i n gs
You can implement various service settings.
Se r v i c e s e t t i n gs
13.1 Changing service settings
Swipe to "Service".
1.
"Application Info" lights up.
a
Touch and change the desired service setting.
2.
Publicidad
