Kaco blueplanet 29.0TL3 S Manual De Instrucciones página 49

Manual
Resistencia aisl.
4 4
1 2 3
40 – 2000 [kOhm] /
200 [kOhm] /
[kOhm]
Vigilancia trifásica
4
1 2 3 4
On / Off
FRT (Fault Ride Th-
1 2 3 4 4
rough)
Modo de funcion. –
1 2 3 4 4
On | Off
Ajustes | Manual |Co-
rriente cero predefini-
da
Prioridad – Limitación
de corriente reactiva |
Prioridad corriente act.
Bajada secuencia pos.
1 2 3 4 4
constante K &
Subida secuencia pos.
constante K
k 0 – 10
Bajada secuencia neg.
1 2 3 4 4
constante K
Subida secuencia neg.
constante K
k 0 – 10
Banda muerta
1 2 4 4
3
2 – 120 [% Uref]
10.0 0.1
Solo cor. react. din.
1 2 3 4 4
Off | On
Modo banda inact.
1 2 3 4 4
Mode 1 | Mode 2
Tensión de ref.
1 2 3 4 4
184 – 248 [V]
[V] 1 [V]
Kaco blueplanet 29.0TL3
Configuration and operation | 9
F Set threshold value at which the insulation monitor reports a fault.
1
AVISO: The device is equipped with redundant 3-phase moni-
toring. If the grid voltage exceeds or drops below the configu-
red values, the device switches off. The minimum switch-off
threshold can be set in 1 V increments.
F Activate or disable monitoring.
AVISO: El equipo admite la estabilización dinámica de red
(Fault-Ride-Through/permanecer en operación durante un fa-
llo en la red). Más información en [Ver capítulo 10.3} Página 68]
F Select a control process.
On: Activates dynamic grid support using dynamic reactive current.
Off: Deactivates dynamic grid support using dynamic reactive current.
Dynamic grid support remains active on account of immunity to interfe-
rence.
F Select a control process.
F Select a control process.
F Set amplification factor k for the pos. sequence for drop and increase
in the grid voltage.
2 0.1
F Set amplification factor k for the neg. sequence for drop and increase
in the grid voltage.
2 0.1
F Set dead band in %.
AVISO: With FRT mode activated, the pre-fault reactive cu-
rrent can be added.
F If necessary, activate pre-fault reactive current.
F Select dead band mode for the active control process.
F Set reference voltage for the active control process.
230
Página 49