Kaco blueplanet 29.0TL3 S Manual De Instrucciones página 53

Manual
1–600 [%/min]
Limitador de arranque
en cada conexión
Estado
Limitador de arranque
en la primera conexión
Estado
Limitador de arranque
tras error de la red
Estado
Estado
Hora Lock-In
4 4
1 2 3
0 – 60 [s] /
1
Hora Lock-Out
0 – 60 [s] /
1
Modo de prioridad
1 2 3 4 4
Prioridad Q | Priori-
dad P
Umbral de activa.
1 2 3 4 4
45 Hz – 70 Hz /
0.01
Gradiente salida ascen-
1 2 3 4 4
diente & Gradiente sa-
lida decreciente
1 – 65534 [% Slim /
min] /
Slim / min] /
Power reduction P(U)
1 2 3 4 4
Modo de funciona-
3
1 2 4 4
miento
Off | On
Potencia de referencia
1 2 3 4 4
Potencia actual | Po-
tencia nominal
Kaco blueplanet 29.0TL3
AVISO: El límite de arranque permite un arranque moderado
de la potencia. Más información en [Ver capítulo 10.4.2} Pági-
na 73]
F Ajuste la pendiente.
1. Active la opción.
2. Active la protección por contraseña opcional.
3. Confirme el campo de acción
F Set the length of time that the active power must remain above the
lock-in / lock-out power level before control is activated.
30 [s] /
30 [s] /
F Set priority for reactive power – Q or active power – P.
AVISO: When it comes to P priority, the reactive power adjust-
ment range is limited subject to the active power that is cu-
rrently available and fed in.
F Specify activation threshold (if mode 1 or mode 2 is active, this menu
option is displayed permanently for IT and IL!)
AVISO: The function is activated if the activation threshold is
exceeded. In mode 2 this value also serves as a deactivation
threshold.
F Specify the increasing and decreasing output gradient.
65534 [%
1
AVISO: To prevent the device from shutting down due to
overvoltage protection, the active power can be regulated in
addition to reactive power control in order to reduce the acti-
ve power feed-in whereby the output voltage is reduced.
F Activate the control process.
Off: Deactivates dynamic grid support using dynamic reactive current.
Dynamic grid support remains active on account of immunity to interfe-
rence.
F Select the power-dependent control method.
Configuration and operation | 9
Página 53