Safety Precautions; General Safety Precautions; Installer's Requisites; Working Clothes - Aprimatic BUONGIORNO Instrucciones Para La Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

2

Safety precautions

2.1 GENERAL SAFETY PRECAUTIONS

Before any operation, the installer shall read this manual thoroughly. In particular, he shall obey all safety precautions
listed below:
Delimit the intervention zone with barriers to prevent non-authorized people from entering the area. If the
installation is done on frames facing pavements or roads, also the area underneath the intervention zone shall
be delimited to make sure that passers-by cannot get injured in the case of accidental fall of objects.
Do not leave the intervention zone unattended.
The intervention zone shall be free from hindrances, well-lit and with non-slip floor.
Use only type-approved means in good conditions.
Disconnect all power sources before installation and maintenance.
Do the interventions according to the manufacturer's instructions.
The installer must check the installation and the proper functioning of the appliance.
After installation, clean the intervention zone thoroughly and collect the wastes into special containers suitable
for differentiated refuse collection.
Periodically check the proper functioning of the operator. Check it at regular intervals of maximum 12 months.
Use only genuine spare parts

2.2 INSTALLER'S REQUISITES

The installation of Aprimatic products shall be entrusted
to qualified technicians having the necessary technical
skill.
The operator shall meet the following criteria:
He shall be attentive and scrupulous and observe
the safety precautions and the environment.
He shall abstain from working under the influence of
drugs or alcoholic drinks that may alter or reduce
his quickness of reflexes.

2.3 WORKING CLOTHES

To work in full compliance with the safety regulations:
wear type-approved working clothes and personal
protection equipment (working shoes, protection
goggles, gloves and hard hat);
during assembly or adjustment operations, the
installer must use harnesses suitably anchored to
fixed elements to prevent serious injury in the case
of accidental fall;
do not wear objects that may get caught (ties,
bracelets, necklaces, etc.).
- 26 -
R

Publicidad

Tabla de contenido
loading

Tabla de contenido