Cantilevered Assembly - Aprimatic BUONGIORNO Instrucciones Para La Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

4
I n s t a l l a t i o n

4.2 CANTILEVERED ASSEMBLY

!
Warning
Make sure that the surface where brackets (2) are
fixed is such to grant a correct horizontal alignment
of the rail.
Shut the wings.
Position template (1) on the window aperture side and
mark the position of the holes used to fix the supporting
brackets.
The template must touch the upper side of the window
aperture (lintel) and the wing of the closed shutter;
carry out the operation from either right and left side.
Information
The use of the template allows keeping the minimum
distance between operator and lintel.
It is possible to install the BUONGIORNO operator
even at a greater distance from the lintel. However, in
this case, it is necessary to respect the alignment
between operator and rotation plane of the wings,
therefore the template shall be aligned only with the
wing of the closed shutter.
Drill 4 holes ø 8 mm (2 on the right and 2 on the left-
hand side of the window aperture). It is recommended
to use wall anchors ø 8 mm and flathead screws
4.9x50 or similar devices that grant a solid fastening.
Fix brackets (2) (code 62324000) to the walls of the
window aperture.
Caution
Make sure that bracketsare well fastened; a proper
fastening is fundamental for a correct functioning of
the automatic operator.
Cut the rail to size; it shall have a length (Lt) equal to
the distance (L) between the two supporting plates
minus 20 mm.
INSIDE
1
10
- 38 -
OUTSIDE
8
Ø
2
L
Lt
Lt = L - 20mm
R
10

Publicidad

Tabla de contenido
loading

Tabla de contenido