Dreame H12 Dual Manual De Usuario página 11

Care and Maintenance
EN
Cleaning the Tube and the Dirt Sensor
Remove the Used Water Tank, wipe the tube and the dirt
sensor with a wet cloth before use.
Cleaning the Dust Cup Assembly
1. Press the dust cup release button and
remove the cup.
3. Tap the filter gently or clean it with the
cleaning brush. Rinse the filter and the
dust cup with water.
Note:
•
Cleaning the dust cup after each use or after the amount of dust in the cup reaches the MAX line is
recommended.
•
Replacing the filter every 3 to 6 months is recommended.
Cleaning the Brush Assembly
1. First, press the brush roller cover
release buttons inwards on both sides to
remove the brush roller cover. Next, press
the brush roller release button and the
handle of the brush roller will pop out.
Pull the handle to take out the brush
roller.
1
2
15 15
2. Take out the filter and the cyclone
assembly from the dust cup, then empty
the cup.
Note: To reduce the risk
of electric shock or injury,
do not rinse the cyclone
assembly with water.
4. Dry the filter and the dust cup
completely before use.
2. Clean out any hair and debris tangled
on the brush roller with the provided
cleaning brush. Rinse the brush roller
with clean water and dry it completely.
Care and Maintenance
3. Wipe the suction inlet with a dry cloth
or wet tissue. Do not rinse the brush
assembly with water.
Note:
•
Clean as needed. Alternating use of the two provided brush rollers is recommended.
•
Replacing the brush roller every 3 to 6 months is recommended.
Cleaning the Soft Roller Brush
1. As shown in the picture, press the
brush roller release button to remove the
roller from the slot.
Cleaning the Motorized Mini-Brush
1. Use a coin as illustrated to rotate the lock counterclockwise, and remove the brush
roller until you hear a click.
2. When it is dirty, rinse the brush roller with clean water. Stand the brush roller upright
until it is fully dry.
4. After cleaning the brush roller, re-install
the brush roller and the brush roller cover.
You will hear a click to indicate that they
are installed in place.
2. When it is dirty, rinse the brush roller
with clean water. Stand the brush roller
upright until it is fully dry.
EN
16 16