EUCHNER CKS-A-LA1-SC Manual De Instrucciones página 4

Operating Instructions
Key Adapter CKS-A-LA1-SC
Inspection and service
WARNING
Loss of the safety function because of damage
to the device.
In case of damage, the entire device must be
f
replaced.
Only accessories or spare parts that can be
f
ordered from EUCHNER may be replaced.
Regular inspection of the following is necessary to
ensure trouble-free long-term operation:
Check the switching function
f
Check the secure mounting of the devices and
f
the connections
Check for contamination.
f
No servicing is required. Repairs to the device are
only allowed to be made by the manufacturer.
Exclusion of liability and warranty
In case of failure to comply with the conditions for
correct use stated above, or if the safety regula-
tions are not followed, or if any servicing is not
performed as required, liability will be excluded and
the warranty void.
Declaration of conformity
The EU declaration of conformity can be found at
www.euchner.com. Enter the order number of your
device in the search box. The document is available
under Downloads.
Service
If servicing is required, please contact:
EUCHNER GmbH + Co. KG
Kohlhammerstraße 16
70771 Leinfelden-Echterdingen
Germany
Service telephone:
+49 711 7597-500
E-mail:
support@euchner.de
Internet:
www.euchner.com
Technical data
Parameter Value
Key adapter
Housing material Plastic (TPU, PBT)
Weight 0.015 kg
Storage temperature -45 ... +85 °C
Operating temperature -20 ... +55 °C
Degree of protection IP65/IP69/IP69K (in installed
state), IP20 on the rear side
Installation position On the front
Installation opening according
Ø 22 mm
to DIN IEC 60947-5-1
Actuating range typ. 5 mm typ.
1)
Assured release distance s 35 mm max.
ar
Assured operating distance s 2 mm min.
ao
Connection to evaluation unit Plug connector M8
(male socket, 3-pin)
Cable length 25 m max.
LED indicator Green: valid key detected
Key
Housing material Plastic (PC)
Weight 0.004 kg
Degree of protection IP65/IP67
Ambient temperature -20 ... +70 °C
Power supply Inductive via read head
1) Referred to the stop of the inserted key.
WH
BN
H11 H12 SH1
Evaluation Unit
Fig. 1: Terminal assignment
Fig. 2: Key adapter mounting
4
The key adapter is intended for mounting in control panels with a
fastening hole Ø 22 mm with protection against twisting according
to DIN IEC 60947-5-1.
3
4
1
View of
plug connector M8
for key adapter
Fig. 3: Dimension drawing
Key adapter
M8X1
36
Key
113461
CKS
FR
5
Active face
‡ 25,4
‡ 31