JBM 54396 Manual De Instrucciones página 100

1.2.12 Operating the truck without its own drive system
If the truck has to be moved after a failure has
rendered it immobile, proceed as follows:
•
Set the emergency stop switch "OFF".
•
Set the key switch "OFF" and remove the key.
•
Prevent the truck from rolling away.
•
Remove the cover.
•
Screw in two screws(1), M4*30mm)until the
truck can be moved (no braking action).
•
Set the emergency stop switch "ON".
•
Set the key switch "ON", which the truck
powered all the time.
After setting down the truck at the destination,
unscrew two screws(1).
Braking action is restored.
i
NOTE
Inoperative trucks movement after brake
release must ensure that the power of
the truck is on or risk damaging the truck
controller.
WARNING
This operating mode is not permitted
when negotiating inclines and
gradients.
B 21
REV. 09/2021