JBM 54396 Manual De Instrucciones página 111

26 Inspect whether the bearing capacity reaches the rated load and implement
corresponding adjustment through the flood valve adopted in the hydraulic
station
27 Inspect whether all the labels are clear and intact
28 Check if there is abrasion between shaft and bearing of front and rear
fork.
29 Check if there is deformation or Check if there is deformation or fracture on
the upper and down connecting rod.
30 Check for looseness of each joint.
31 Add lubricating grease to the pin roll.
2000-hour/12-month maintenance
After operating for 2000 hours in total, the truck should also be maintained according to the
following procedures in addition to the 50-hour maintenance, 250-hour maintenance, 500-hour
maintenance and 1000-hour maintenance mentioned above
32 Check hydraulic oil level.
33 Replace hydraulic oil.
Contact surface
Hydraulic oil injection nozzle
Grease
REV. 09/2022
D
6
Fig1154-00023OM