Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: Use of this tool can generate and/or disperse dust, which may cause serious
and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory
protection appropriate for the dust exposure. Direct particles away from face and body.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
Specifi cations
Amperes
15 A
Table Size
21-7/8" (556 mm) X 26-3/8" (669 mm)
Miter Angle
30° L&R
Bevel Angle
0° to 45°L
Blade Size
10" (254 mm)
Max. Cut Depth, 0° Bevel
3-1/8" (79 mm)
Max. Cut Depth, 45° Bevel
2-1/4" (57 mm)
RPM, no load
4800
Unpacking (Fig. 1)
FIG. 1
WARNING: To reduce the risk of injury,
DO NOT connect the machine to the
power source until the table saw is
completely assembled and you have read
the entire instruction manual.
Open the box and slide the saw out, as
shown in Figure 1.
Carefully unpack the table saw and all
loose items from the carton. Examine all
parts to make sure that parts have not
been damaged during shipping. If any parts
are missing or damaged, contact your
dealer to replace them before attempting
to assemble the tool.
FEATURES (Fig. 2, 3)
WARNING: Never modify the power tool or any part of it. Damage or personal injury could
result.
Examine Figures 2 and 3 to become familiar with the saw and its various parts. The following
sections on assembly and adjustments will refer to these terms and you must know what and
where the parts are.
A. Table
M. Splitter
B. Blade
N. Anti-kickback assembly
C. Rip scale indicator
O. Dust collection port
D. Fine adjust knob
P. Guard dust collection port
E. Rail lock lever
Q. Throat plate
F. Blade height adjustment wheel
R. Rip fence
G. Bevel lock lever
S. Rip fence latch
H. ON/OFF switch
T. Work support/narrrow rip fence (shown
in stored position)
I. Mounting holes
U. Blade wrenches (stored position)
J. Miter gauge
V. Push stick (stored position)
K. Blade guard assembly
W. Riving knife (non thru sawing) (FIG. 27)
L. Riving knife/blade guard release lever
FIG. 2
K
Q
A
L
J
C
H
FIG. 3
V
T
S
INTENDED USE
This table saw is designed for professional ripping, crosscutting, mitering, beveling and non
thru-cutting applications, such as dadoing, with various materials.
DO NOT use for cutting metal, cement board, or masonry.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
DO NOT let children come into contact with the tool. Supervision is required when
inexperienced operators use this tool.
4
T
R
S
E
D
F
G
P
B
M
N
U
O
I
Publicidad
