Craftsman 139.30437 Manual Del Propietário página 31

Features(Continued)
USINGYOUR GARAGEDOOROPENER
The garage door opener can be activated through a wall-mounted
door control, remote control, wireless keyless entry or
AssureLink
TM
accessory.
When the door is closed and the garage door opener is activated
the door will open. If the door senses an obstruction or is
interrupted while opening the door will stop. When the door is in
any position other than closed and the garage door opener is
activated the door will close. If the garage door opener senses an
obstruction while closing, the door will reverse. If the obstruction
interrupts the sensor beam the garage door opener lights will
blink 10 times. However, you can close the door if you hold the
button on the door control or keyless entry until the door is fully
closed. The safety reversing sensors do no effect the opening
cycle.
The safety reversing sensor must be connected and aligned
correctly before the garage door opener will move in the down
direction.
Door Contro/
USINGTHE DOORCONTROL
Push Bar
1 Minute
TTC LED
5 Minute
TTC LED
10 Minute
TTC LED
HOLD Buttonfor the
Timer-To-Close ( TTC)
LIGHT
Button
Motion
Sensor
Push Bar
Press the push bar to open or close the door.
Light Button
Press the LIGHT button to turn the garage door opener lights on
or off. When the lights are turned on they will stay on until the
LIGHT button is pressed again, or until the garage door opener is
activated. Oncethe garage door opener is activated the lights will
turn off after the specified period of time (the factory setting is
4-1/2 minutes). The LIGHTbutton will not control the lights when
the door is in motion. The duration of the light timing can be
adjusted using the door control.
The following features are accessibleby lifting the push bar on
the Motion-DetectingControlPanel:
LEARNA DEVICE
Any compatible remote controls, wireless keyless entry, or
AssureLink
TM
accessories can be programmed to the garage door
opener by pressing the Learn button on the Motion-Detecting
Control Panel.
Lock
The LOCKfeature is designed to prevent activation of the garage
door opener from remote controls while still allowing activation
from the door control and keyless entry. This feature is useful for
added peace of mind when the home is empty (i.e. vacation).
Tlmer-to-C/ose(TTC)
DO NOT enable TTCif operating a one-piece door. TTC is to be
used ONLYwith sectional doors.
Factory default is set to off. TTCcan be set to automatically close
your garage door from the fully open position after a specified
period of time (1, 5, 10 minute intervals). The garage door opener
will beep and the lights will flash before closing the door. If the
door encounters an obstruction while closing, the garage door
opener will make a second attempt to close the door. If the
obstruction has not been cleared after the second attempt, the
garage door opener will reverse open, stop and WILL NOTclose
until the obstruction has been cleared. TTCWILL NOTwork if the
safety reversing sensors are misaligned. This feature is NOT
intended to be the primary method of closing the door. A keyless
entry shouldbe installed in the event of an accidental lock out
when using this feature.
AUTOMATICLIGHT
Motion Sensor
Factory default is set to on. This feature will automatically turn on
the garage door opener lightswhen motion is sensed.The lights
will come on for the set period of time, then shut off.
The lightswill turn on when someone enters through the open
garage door and the safety reversing sensor infrared beam is
broken.
If using the garage door opener light as a work light disable the
Automatic Light Feature,otherwise the light will turn off
automatically if you are beyond the range of the sensor.
31