Craftsman 139.30437 Manual Del Propietário página 33

Programming
Your garage door opener has been programmed at the factory to operate with your remote control. The remote control can be
programmed using the door control or the garage door opener. To program additional remote controls refer to the instructions provided
with the additional remote controls.
PROGRAMA REMOTEUSINGTHE LEARNBUTTON TO ADD, REPROGRAIVl, ORCHANGE A REMOTECONTROL/
KEYLESS ENTRYPIN USINGTHE MOTION-DETECTING
CONTROLPANEL
1. Press and releasethe Learn button on
the garage door opener. The Learn
indicator light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold the
button on the remote control.
1. Press the LEARN button on the door
control to enter Programming Mode.
2. Press the LEARN button again, the
LED will flash once.
The command LED
will flash once.
The command LED
will flash once again.
3. Releasethe button when the garage
door opener light blinks. It has learned
the code. If light bulbs are not installed,
two clicks will be heard.
When replacing the light lens cover, ensure the antenna wires are
hanging straight down.
3. Press the button on the remote
control that you wish to operate
your garage door.
OR
Enter a 4-digit personal identification
number (PIN) of your choice on the
keyless entry keypad.Then press
the ENTERbutton.
The garage door opener lights will
flash (or two clicks will be heard) when
the code has been programmed.
Repeat the steps above for
programming additional remote
controls or keyless entry devices.
OR
? ? ?
PIN
To Erase the Memory
ERASE ALL REMOTECONTROLSAND KEYLESS ENTRIES
1. Press and hold the learn button on garage door opener until the
learn LEDgoes out (approximately 6 seconds). All remote
control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASEALLDEVICES
1. Press and hold the learn button on garage door opener until the
learn LEDgoes out (approximately 6 seconds).
2. Immediately press and hold the learn button again until the
learn LEDgoes out. All codes are now erased.
Reprogram any accessoryyou wish to use.
33