Publicidad
Idiomas disponibles
Idiomas disponibles
x Connecting to a Macintosh or compatible
computer
You will need a Macintosh adapter (not supplied).
Macintosh or compatible computer
x Connecting to a second computer
Refer to the preceding
examples to connect your
computer.
Downloaded from:
https://www.usersmanualguide.com/
2
1
AC IN
Macintosh adapter
(not supplied)
to video output
2
1
AC IN
to HD15
video signal cable
(not supplied)
Step 2: Connect the power cord
With the monitor and computer switched off, first connect the
power cord to the monitor, then connect it to a power outlet.
to AC IN
to a power outlet
power cord (supplied)
Step 3: Turn on the monitor and
computer
First turn on the monitor, then turn on the computer.
The installation of your monitor is complete.
If necessary, use the monitor's controls to adjust the picture.
If no picture appears on your screen
• Check that the monitor is correctly connected to the computer.
• If NO SIGNAL appears on the screen, try changing the input
signal (page 8), and confirm that your computer's graphics
board is completely seated in the correct bus slot.
• If you are replacing an old monitor with this model and OUT
OF SCAN RANGE appears on the screen, reconnect the old
monitor. Then adjust the computer's graphics board so that the
horizontal frequency is between 30 – 110 kHz and the vertical
frequency is between 48 – 170 Hz.
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 19.
Setup on various OS (Operating System)
This monitor complies with the "DDC" Plug & Play standard and
automatically detects all the monitor's information. No specific driver
needs to be installed to the computer.
If you connect the monitor to your PC, and then boot your PC for the first
time, the setup Wizard may be displayed on the screen. Click on "Next"
several times according to the instructions from the Wizard until the Plug
& Play Monitor is automatically selected so that you can use this monitor.
AC IN
US
7
Publicidad
