Kenmore ELITE 625.382080 Manual Del Propietário página 10

INSTALL VALVE DRAIN HOSE SINGLE BYPASS VALVE
1. Measure, cut to needed length and connect the 3/8"
drain line (provided) to the Central Water Whole Home
Filtration System valve drain fitting (See Figure 10).
Use a hose clamp to hold the hose in place.
NOTE: If codes require a rigid drain line see "Valve
Drain requirements" section.
2. Run the drain hose or copper tubing to the floor drain.
Secure drain hose. This will prevent the drain line
from "whipping" during Clean Rinse cycles. See "Air
Gap Requirements" section.
TEST FOR LEAKS
1. Make sure the single bypass valve (or 3 valve bypass,
if installed) is in the bypass position, with the handle
pushed in (See Figure 10).
2. Fully open the main water supply valve.
3. Briefly open a faucet in the house to refill the plumb-
ing with water.
4. Place the bypass valve(s)in normal operation posi-
tion, with the handle pulled out (See Figure 10).
5. Check for leaks at all the plumbing connections you
made.
IMPORTANT: Start up procedure must be run prior to
using any filtered water. Follow the
instructions below and on Page 13.
Drain Line
Connection
__] Pull handte
OUoTfe°ratq° _mat
T_
Push handle IN
for BYPASS
Figure 10
TURN ON THE CENTRAL WATER WHOLE
HOME FILTRATION SYSTEM
During installation, the Central Water Whole Home
Filtration System wiring may be moved or jostled from
place. Check to be sure all leadwire connectors are
secure on the back of the electronic board (see Figure
24 on Page 23) and be sure all wiring is away from the
valve gear and motor area, which rotates during Clean
Rinse cycles.
,
,
Plug the Central Water Whole Home Filtration
System's transformer into an electrical outlet that is
not controlled by a switch.
In the display, the words "SET TIME" appear and
12:00 PM begins to flash. Set the clock according to
the "Set Time of Day" section on Page 12.
3. Run the start up procedure, as detailed on Page 13.
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
10