Publicidad
Idiomas disponibles
Idiomas disponibles
INLET - OUTLET PLUMBING OPTIONS
Install a single bypass valve (provided) to the plumb-
ing, as shown in Fig. 8 OR if desired, a 3 valve bypass
system (parts not included) can be installed, as shown
in Figure 7. Bypass valves allow you to turn off water
to the Central Water Whole Home Filtration System for
maintenance
if needed, but still supply water to the
house.
3 VALVE BYPASS
Use either:
• Copper pipe
• Threaded pipe
• PEX (Crosslinked Polyethylene)
pipe
• CPVC plastic pipe
• Other pipe approved for use with potable water
IMPORTANT: Do not solder with plumbing attached to
installation adapters and single valve
bypass. Soldering heat will damage the
adapters and valve.
NOTE: Before installing the bypass valve or copper
tube into the valve's INLET, remove the foam
piece that was placed in that port for shipping.
Before installing the bypass valve or copper tube into
the valve's OUTLET, make sure that the turbine and
support are firmly in place, as shown in Figure 6.
Turbine
Valve
Support
Outlet
Turbine
/
Central Water Filtration
System OUTLET
Central Water Filtration
System INLET
Figure 7
CONNECTING
PLUMBING
TO VALVE
OUT
Use teflon
tape,
pipe joint com-
pound or both
Figure
6
Use teflon tape,
pipe joint com-
pound or both
IN
1" NPT
Sweat
Adapter (2)
(not included)
@
41.--- ,_'dNpP:r
%
Valve
Bypass
Valve
Inlet
2 of each
included
Valve
Inlet
OUT
!
IN
1" NPT Sweat
Adapter (2)
(not included)
Clip
1" NPT
Adapter
_
J
2 of each
included
Figure 8
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
Publicidad
