Unpack and Check Shipment .....................................................................
4
Installation Requirements
......................................................................
5-6
Installation
.................................................................................
7-10
How a Central Water Filtration System Works .......................................................
11
Programming the Central Water System
...........................................................
12
Start Up Procedure
............................................................................
13
Customizing Features / Options
...............................................................
14-16
Care of Your Central Water Filtration System .....................................................
17-18
Troubleshooting
............................................................................
19-21
Dimensions
..................................................................................
22
Specifications
................................................................................
23
Wiring Schematic
.............................................................................
23
Exploded View & Parts List ...................................................................
24-27
•
Read all steps and guides carefully before installing
and using your Central Water Whole Home Filtration
System.
Follow all steps exactly to correctly install.
Reading this manual will also help you to get all the
•
benefits from the Central Water Whole Home Filtration
System.
• Do not attempt to use this product to make safe drink-
ing water from non-potable water sources.
Do not
use the system on microbiologically
unsafe water, or
water of unknown quality without adequate disinfec-
•
tion before or after the system.
• Use only lead-free solder and flux for all sweat-solder
connections, as required by federal codes.
• Use care when handling the Central Water Whole
Home Filtration System.
Do not turn upside down or
drop.
• Avoid installing in direct sunlight.
Excessive sun heat
may cause distortion or other damage to non-metallic
parts.
•
• Check with your local public works department for
plumbing and sanitation codes. You must follow their
guides as you install the system.
Follow your local
codes if they differ with guides in this manual.
In
Massachusetts,
plumbing code 248-CMR 3.00 and
10.00 shall be adhered to. Consult with a licensed
plumber.
The Central Water Whole Home Filtration System
works on water pressures of 30 psi (minimum) to 125
psi (maximum).
If your house water pressure is over
the maximum, install a pressure reducing valve in the
water supply pipe to the Central Water Home
Filtration System.
The Central Water Whole Home Filtration System
works on 24 volt, 60 Hz electrical power only, supplied
by a direct plug-in transformer (included).
Be sure to
use the included transformer and plug it into a nomi-
nal 120V, 60 cycle household outlet that is properly
protected by an overcurrent device such as a circuit
breaker or fuse.
If transformer is replaced, use only
the authorized service, Class II, 24V 10VA trans-
former.
Do not install the Central Water Whole Home
Filtration System outside, or in extreme hot or cold
temperatures.
Temperature of the water supply to the
Central Water Whole Home Filtration System must be
between 40°F and 120°F. Do not install on hot water.
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com