Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
-
Remove the battery and store it in a safe, dry place if the device will not be used for a long
period of time.
-
To replace the battery, follow the instructions below:
1.
Unscrew the 2 screws on the battery slot, remove the battery cover and the battery. Fig. 27
2.
Insert the new battery with the battery label facing up. Fig. 28
3.
Place the battery and the battery cover in its place and fix properly the screws back
again.
6. TROUBLESHOOTING
Robot signal
Cause
1 beep
Omnidirectional wheel
error.
2 beeps
Side brushes error
Steady
red light
3 beeps
Suction motor error
4 beeps
Main brush error
46
Solution
Clean the omnidirectional wheel and
press the Start/Pause button to restart
the robot vacuum cleaner.
Clean the side brushes and press the
Start/Pause button to restart the robot
vacuum cleaner.
Remove the tank and empty it.
Remove the robot filter and shake off
the dirt.
Remote and clean the main brush and
press the Start/Pause button to restart
the robot vacuum cleaner.
1 beep
Mixed tank error
Flashing
red light
2 beeps
Bumper error
Free-fall sensor error
3 beeps
4 beeps
The robot cannot return
to its charging base or
starting position.
7. TECHNICAL SPECIFICATIONS
Product: Conga 1990 Titanium
Product reference: 05692
Voltage: 100-240 V ~, 50/60 Hz
Rated capacity: 14.4 V DC 2500 mAh
Typical capacity: 2600 mAh
Frequency bands: 2.4 GHz
Maximum Transmission Power: 17.5 dBm
Technical specifications may change without prior notification to improve product quality.
Manufactured in China | Designed in Spain
8. DISPOSAL OF OLD ELECTRICAL APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or battery must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should
dispose of the batteries/accumulators and take them to a collection point
ENGLISH
Introduce the mixed tank and press the
Start/Pause button to restart the robot
vacuum cleaner.
Check if the bumper is blocked and
press on both sides and center to
unblock it.
Check if the robot is placed on an
uneven surface, if its wheels are off
the ground or if it is stuck in a dark
place and move it to a new location.
Otherwise, clean the free-fall sensor.
Make sure there are no obstacles
in front of the charging base. Clean
the charging terminals on both the
charging base and the robot with a
clean, soft and dry cloth.
47
Publicidad
