cecotec CONGA QUICK&CLEAN TITANIUM Manual De Instrucciones página 46

ENGLISH
affecting negatively to the cleaning efficiency. For this reason, it is suggested to replace each
side brush after a maximum of 220 hours or less.
Recommendation
It is recommended to clean the side brushes once a week with the help of the autoclean brush.
Sensors
Your robot vacuum cleaner has different types of sensors, for example, proximity sensors
-
that allow the robot to move around while detecting obstacles, or free-fall sensors that
help the robot detect slopes or possible gaps/unevenness such as staircases. These
sensors are always in contact with dust particles, and therefore can deteriorate over time,
causing possible navigation errors.
It is suggested to clean all the robot sensors with a dry and soft cloth after a maximum of
-
35 hours of operation or less.
Battery charge and replacement
To lengthen the battery shelf life, keep the robot charging on the charging base when not
-
in use.
Remove the battery and store it in a safe, dry place if the device will not be used for a long
-
period of time.
To replace the battery, follow the instructions below:
1. Unscrew the 2 screws on the battery slot, remove the battery cover and the battery. Fig. 33
2. Insert the new battery with the battery label facing up. Fig. 34
3. Place the battery and the battery cover in its place and fix properly the screws back again.
6. TROUBLESHOOTING
Robot signal
1 beep
2 beeps.
Steady red
light
4 beeps
46
Cause
Omnidirectional
wheel error
Side brush error
Jalisco brush
error.
Solution
Remove the wheel, clean it and once it is
placed again, press the Start/Pause button
to restart the robot vacuum cleaner.
Remove the side brushes, clean them and
once they are placed again, press the Start/
Pause button to restart the robot vacuum
cleaner.
Remove and clean the Jalisco brush. Once it
is placed again, press the Start/Pause button
to restart the robot vacuum cleaner.