Publicidad
Idiomas disponibles
Idiomas disponibles
4. Use the nozzle-cleaning needle provided or any pointy, thin item to clean the nozzle, e.g.,
insert an unfolded paper clip into the nozzle hole. Move it inwards and outwards until all
dust and dirt is removed. Fig. 9
5. Pour water through the nozzle hole into the nozzle to clean the dirt remains. To do this,
point a lighted garden hose at the nozzle for 30-60 seconds.
6. TROUBLESHOOTING
Problem
Smoke comes out of
the device.
There is not enough
pressure.
The pressure washer
does not turn on.
Pressure fluctuates.
Possible causes
Overheating, overloading, or
motor failure.
The water inlet filter is
clogged.
Air is entering from the hose
connections to the pump.
The nozzle or discharge
valve is worn or are not of
the correct size.
The unit is pressurised.
The plug is not properly
connected, or the socket is
defective.
The extension cord is too
long or short.
The supply voltage is too
low.
The thermal safety switch
has tripped.
The pump is sucking in air.
The nozzle is clogged.
The valves are dirty or worn.
Hydraulic seals are worn.
Possible solutions
Switch off the device immediately
and contact
the Technical Support
Service of Cecotec.
Clean the water inlet filter.
Check that the connections and the
locking ring are tight.
Contact the Technical Support
Service of Cecotec
Press the gun trigger.
Check the plug,
the socket, and fuses.
Remove the extension cord.
Make sure that the mains voltage
matches the voltage stated on the
rating label of the appliance.
Switch off the device and allow it
to cool down.
Check that hoses and connections
are airtight.
Clean them with the nozzle-
cleaning needle.
Contact the Technical Support
Service of Cecotec.
HYDROBOOST 3200 TOTALCLEAN
ENGLISH
77
Publicidad
