cecotec CONGA 999 ORIGIN GENESIS Manual De Instrucciones página 50

ENGLISH
sensors. If this happens, the robot vacuum cleaner will cease operation. Move it to a new
location for it to start running again.
3. INSTALLATION
Place the charging base against a wall and leave a minimum free space of 1.5 metres to
1.
the front and 0.5 metre to each side. Fig. 4
2. Connect the charging base to a power socket. Wind and store the remaining cord in the
lower part of the charging base to prevent accidents.
3. Install both side brushes in their corresponding slots, located on the bottom part of the
robot vacuum cleaner. Press until they click into place. Fig. 5
Place the robot vacuum cleaner in the charging base and make sure the charging terminals
4.
on the robot match those of the base. Once the robot vacuum cleaner is properly placed,
it will beep once, and the light indicator will come on. If the light is flashing, it means the
battery is not completely charged. To ensure the maximum cleaning time, wait until the
light turns steady, as this will indicate the battery is fully charged and the robot vacuum
cleaner is ready to clean. Fig. 6
4. OPERATION
Start cleaning
- Hold down the Start/Pause button on the robot vacuum cleaner to turn it on.
- Press the Start/Pause button on the robot vacuum cleaner, on the remote control, or on
the app to start cleaning.
Note
- If the robot vacuum cleaner runs out of battery while cleaning, it will automatically return
to the charging base. Once the battery is fully charged, the robot can start a new cleaning
cycle.
- If there is no good access to the charging base, the robot vacuum cleaner will not be able
to return to it. If this happens, place it manually on the charging base.
End cleaning
- Press the Start/Pause button on the robot vacuum cleaner, on the remote control, or on
the app to pause the cleaning process.
- Press the Start/Pause button on the robot vacuum cleaner, on the remote control, or on
the app to resume the cleaning process.
50
CONGA 999 ORIGIN GENESIS