cecotec CONGA 999 ORIGIN GENESIS Manual De Instrucciones página 55

6. TROUBLESHOOTING
Beeps Error
1 Low battery
Drive wheel fault.
2 Side brush error.
3 Suction motor
error.
4 Main-brush fault.
5 Bumper error.
Fall-detection
sensor error.
Main brush error.
6 Charging error.
7. TECHNICAL SPECIFICATIONS
Conga 999 Origin Genesis / X/ T/ S/ M
Product reference: 08093/ 08074/ 08075/ 08076/ 08077
Input: 19V DC 0.6 A
Battery: 14.4 V DC Li-ion 2000mAh
Solution
Place the robot in the charging base.
Check if the drive wheel is blocked.
Check if the side brushes are blocked and clean them.
Check if there are obstructions blocking the air inlet.
Empty the tank.
Clean the filters with a vacuum cleaner or a self-cleaning
brush.
Check if the filters are wet.
Dry the filters in a natural way before using them. Make sure
they are completely dry. If any moisture remains, it could
reach the motor and damage the robot vacuum cleaner.
Check if the main brush is blocked or tangled and clean it.
Carefully clean the sensors with a clean, dry cloth.
Restart the robot vacuum cleaner. To do this, switch the
robot off and on.
Carefully clean the sensors with a clean, dry cloth.
Restart the robot vacuum cleaner. To do this, switch the
robot off and on.
Clean the main brush.
Check if the main brush is installed correctly.
Check if the charging base indicators are on. Otherwise,
contact the official Technical Support Service of Cecotec.
Clean the charging terminals with a clean, dry cloth.
Check if the robot vacuum cleaner beeps when it gets to the
charging base. Contact the official Technical Support Service
of Cecotec.
ENGLISH
CONGA 999 ORIGIN GENESIS
55