Publicidad
Idiomas disponibles
Idiomas disponibles
2A-2
2A-3
2A-4
A1
Position the wall plate template [04]
at your desired height and line up
the holes with your stud center line.
Level the wall plate template [04]
04
and mark the holes.
Drill pilot holes using a 7/32 in
(5.5mm) diameter drill bit. Make
sure the depth is not less than
2 3/4 in (70mm).
Note: Do not use a drill to tighten the
lag screws. Only use a socket wrench.
01
10
(Not Included)
2 3/4 in (70mm）
Install the wall plate using lag
screws [A1]. Tighten the lag
screws [A1] is pulled firmly
against the wall plate. DO NOT
over-tighten the lag screws
[A1].
Level
(Not Included)
Pencil
Level
(Not Included)
Electric drill
(Not Included)
1/2 in (13mm)
Socket Wrench
(Not Included)
Publicidad
