ErgoAV ERMTM2-01B Manual De Instrucciones página 13

2B-3
Use the hammer to knock anchors [A2] into the wall. Be sure
the anchors [A2] are seated flush with the concrete surface.
Install the wall plate [01] using lag screws [A1]. Tighten the lag
screws [A1] is pulled firmly against the wall plate [01]. DO NOT
over-tighten the lag screws [A1].
Note: Do not use a drill to tighten the
lag screws. Only use a socket wrench.
A2
01
A1
(Not Included)
12
Hammer
(Not Included)
1/2 in (13mm)
Level
Socket Wrench
(Not Included)