Goodyear GY 2802PS Manual De Instrucciones página 27

English • Owner´s manual
5. Improper use may result in fluid leaking out of the battery. Avoid any contact with battery
fluid. Flush with water in case of contact. If battery fluid should get into your eyes, seek
medical advice additionally. Leaking battery fluid may lead to irritations of the skin or burns!
ATTENTION!
Have the power tool serviced by qualified technical personnel only; repairs should be carried
out using exclusively original spare parts. This will ensure the safe operation of the power tool.
Pruning shear special safety instruction
1. Keep anybody away at least 1.5m from the blade, do not move the tool while in use.
2. Keep any part of your body away from the blade at least 15cm. Careful use of the tool can prevent
tool can prevent injury.
3. Keep the tool well adjusted and sharp. Do not leave the blade open when not working or in storage.
Protect it to reduce the risk of injury.
WARNING:
DO NOT allow comfort or familiarity with the product (obtained with repeated use) to avoid strict
compliance with the safety standards of the product in question. Misuse or breach of the safety rules
set forth in this instruction manual can cause serious personal injury.
Warnings anti-cutting system
DANGER! Anti-cut system
The sensor of the anti-cut system is affected by the use of gloves or use in humid
environments, so its activation is not recommended in these cases.
WARNING! Anti-cut system
The anti-cut system is a safety system that reduces the risk of cutting, although this
risk is always present. Exercise caution when using the scissors.
Special safety instruction for battery tool
1. Make sure the tool is turned OFF before disconnecting the battery. Equipment may be damaged.
2. Charger design for use only indoor. Charging operations have to be performed indoor.
3. Disconnect power before to clean the charger to avoid damage and risk of electrical shock.
4. Don't expose battery in strong light. Don't put battery on hot surface. It can cause battery explosion.
5. Fully cold battery before charging.
6. Don't disassemble the battery, don't damage battery, in order to avoid injury.
Use charger correctly
1. Use the battery charger only with rechargeable cells. Otherwise, it may cause fires and explosions.
Use only the original battery charger.
2. Always check the condition of the charger, cable and plug before each use. If damaged, always
contact a service technician for repair or replacement. Do not use damaged chargers. Do not
attempt to repair the damaged battery charger to keep the tool safe.
3. Verify that the output voltage and charger connector match the proper battery, failure to do so could
result in personal injury and damage to the tool.
4. Connect the battery to the charger before plugging it into the power outlet.
27