Dual CR 900 RC Instrucciones De Manejo página 28

IMPORTANT SAFEGUARDS
1. Read Instructions — All the safety and operating instructions should be read before the
appliance is operated.
2. Retain instructions — The safety and operating instructions should be retained for future
reference.
3. Heed Wamings — All wamings on the appliance and in the operating instructions should
be adhered to.
4. Follow instructions — All operating and use instructions should be followed.
5. Water and Moisture — The appliance should not be used near water — for example, near a
bathtub, washbow, kitchen sink, laundry tub, in a wet basement, or near a swimming pool.
6. Carts and Stands — The appliance should be used only with a cart or stand that is
recommended by the manufacturer.
7. Wall or Ceiling Mounting — The appliance should be mounted to a wall or ceiling only as
recommended by the manufacturer.
8. Ventilation — The appliance should be situated so that its location or position does not
interfere with its proper ventilation. For example, the appliance should not be situated on a
bed, sofa, rug, or similar surface that may block the ventilation ; or, placed in a built-
in installation, such as a bookcase or cabinet that may impede the of air through the
ventilation openings.
9. Heat — The appliance should be situated away from heat sources such as radiators, heat
registers, stoves, or other appliances (including amplifiers) that produce heat.
10. Power Sources — The appliance should be connected to a power supply only of the type
described in the operating instructions or as marked on the appliance.
EXCLUSIVE NOTE FOR U.K.
if your unit comes with a 2-core cable without a plug, make certain live and neutral leads
are connected to the proper terminals. Check that the terminals are screwed down
firmly and no loose strands of wire are present.
IMPORTANT: | The wires In this mains laad are coloured In condens vt the
11. Grounding or Polarization — The precautions that should be taken so that the grounding
or polarization means of an appliance is not defeated.
12. Power-Cord Protection — Power-supply cords should be routed so that they are not
likely to be walked on or pinched by items placed upon or against them, paying particular
attention to cords at plugs, convenience receptacies, and the point where they exit from the
13. Cleaning — The appliance should be cleaned only as recommended by the manufac-
turer.
14. None Рейса Tha er —
when left unused for a long period of time.
15. Object and Liquid Entry Gare should be taken so that objects do not fall and liquids are
not spilled into the enclosure through openings.
16. Damage Requiring Service — The appliance should be serviced by qualified service
personnel when:
A The power-supply cord or the has been damaged; or
B. Objects have fallen, or ud PS ian sped UC O cronos; or
C. The appliance has been exposed to rain; or
D. The appliance does not appear to operate normally or exhibits a marked change in
performance; or
E. The appliance has been dropped, or the enclosure damaged.
17. Servicing — The user should not attempt to service the appliance beyond that described
in the operating instructions. All other servicing should be referred to qualified service
Power Lines — An outdoor antenna should be located away from power lines.
Outdoor Antenna Grounding — If an outside antenna is connected to the receiver, be sure
1984, with respect to proper grounding of the mast and
structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding
conductors, of antenna-discharge unit, connection to and
requirements for the grounding electrode.
а- Use No. 10 AWG (5.3 mm?) copper, No. 8 AWG (8,4 mm?) aluminium, No. 17 AWG
(1.0 mm?) copper-clad steel or bronze wire, or larger as a ground wire.
b- Secure antenna lead-in and ground wires to house with stand-off insulators spaced
——" .22-1.83 m) apart.
c- antenna discharge unit as close as possible to where lead-in enters house.
d- a dra SANG (139 m$ copper, or the equivalent,
when a.separate antenna-grounding electrode is