Stalgast 801556V06 Instrucciones De Uso página 31

It is prohibited to store the elements of the device and the device itself directly in the natural environ-
ment. The device is made of stainless steel and the elements which can be easily removed. The
plastic components of the device are marked with an appropriate symbol.
All connections to the device must meet the standards applicable in the place of installation.
The manufacturer is not liable for any injuries or damage to the product resulting from failure to
comply with the standards applicable in the place of installation. Before installing the device, it is
necessary to make sure that the moisture-sensitive elements are properly secured against getting
wet, e.g. during the cleaning of the device. The device should be placed in the desired location and
then the protective packaging should be removed. The device should be leveled using a spirit level
and four adjustable legs in order to ensure its stability. Any other way of leveling the device should be
approved by the manufacturer.
4.2. Connection to the power supply source
The device's connection to the electrical network may only be executed by the employees of the
technical service or a person with appropriate licenses in accordance with the applicable laws. The
electrical parameters of the device were included in the table in point 3. It is prohibited to execute one
electrical protection for two devices. It is necessary to install an external safety switch and a residu-
al-current circuit breaker. Both switches must be installed in a quickly and easily accessible place in
such a way, that they guarantee the disconnection of the device from the electric power source in
accordance with category II.
The power cord connected to the terminal box with and appropriate plug is NOT supplied with the
device and must be purchased separately.
Conditions for connection to the electrical installation:
• Check whether the voltage in the power supply network is consistent with the voltage indicated
on the nameplate of the device.
• You must necessarily join the device to the installation of equalising electrical potentials with
the help of equipotential bolt (Fig. 6 Pos. 1) placed in the back of the device. It is marked by the
following symbol:
To join the device to the installation of equalising electrical potentials, you must:
• Remove the nut from the bolt
• Introduce equpotential's cable
• Tighten the nut until it stops
• You must plug the second end of equipotential cable in the countervailing rail.
Connection of the device with installation of equalising electrical potentials.
• Manual devices (801505, 801506, 801507, 801516, 801517) that are designed for connection
of the power supply to the terminal box, can be connected in two ways in accordance with the
diagram placed on the label (fig. 2) located on the back of the device. A standard connection is
made for a 400V power supply. The type of the cord is given in table in point 3.
U=400V; P=4500W U=230V; P=3000W
Fig. 2 - Label with connecting diagram
- 31 -
PE – protective wire (yellow-green)
N – neutral wire (blue)
L1, L2, L3 – phase wires (other colors)