Stalgast 801556V06 Instrucciones De Uso página 40

In order to ensure the proper operation of liquid dispensers it is recommended that the tubes are
replaced every 6 months.
At least once a year the device should be inspected in order to check the degree of wear and to
identify possible faults of the components and parts of the device. In case any faults are detected,
they have to be removed by a qualified technical personnel (technical service). The technical service
should pay particular attention to:
• the condition of the heating elements
• the condition of the electrical installation
• the condition of the heating elements protections
• the degree of wear of the device
Although a special program of periodic device inspections has not been developed, it is recommen-
ded that the correct operation of the device and its security features are verified by the technical
service two times per year. Any possible damage or failure of the device caused by the user's non-
-compliance with the guidelines contained in this manual, as well as their failure to comply with the
applicable laws and standards, will not be treated as a liability of the manufacturer.
8.1. Breaks in the operation of the device
If it is expected that the device will not be used for a longer period of time, it is necessary to empty
the containers for the detergent and the rinse aid in order to prevent their crystallization and the re-
sulting pump damage. In connection with the above, it is necessary to remove the suction tubes from
both containers and place them in a bowl filled with clean water, carry out several washing cycles and
then empty the tank of water. Finally, the main switch should be turned off and the water valve should
be closed. The suction tubes should be reconnected to the containers only once the device is used
again (the clear tube to the detergent container and the clear tube with a blue cover to the rinse aid
container).
It is prohibited to leave an activated device and an open water valve for a longer period of downtime
in the device operation.
In winter period, the device must be stored in a heated room. Otherwise, make sure that no fluids
have remained in the device (e.g. boiler, detergent pipes).
9. PACKAGING, LOADING AND TRANSPORT
The washer is packaged in accordance with the applicable standards. The loading of the device onto
means of transport and the unloading should be carried out using appropriate lifting equipment and
trucks. The devices should be transported on covered means of transport. During transportation the
washer should be protected against movement, strong shock and other mechanical damage.
10. DISPOSING OF USED EQUIPMENT
Information for users about the proper principles of disposal of waste electric and electronic equip-
ment
• Leave the old device in the store where you are buying a new device. Each store has an obligation
to take your old equipment free of charge if you buy new equipment of the same type and in the
same quantity. The only condition is to deliver the equipment to the store at your own expense.
• Take the used device to a collection point. You will find information about the nearest location on
the municipal website or bulletin board of the municipal office.
• Leave the device at the service point. If the repair of the device is uneconomical or impossible for
technical reasons, the service is obliged accept the device free of charge.
• Return used equipment without leaving your house. If you don't have the time or ability to trans-
port your equipment to a collection point, you can use the services of specialized companies.
Remember! Do not dispose of used equipment along with household waste. This could cause high
fines.
The symbol of the crossed-out waste bin on the product, its packaging or the instruction
manual means that the product should not be disposed of to normal waste bins. The
user is obliged to hand over the used equipment to a designated collection point for
proper processing.
- 40 -