1
General information
WARNING
Danger due to improper handling of the device!
Read and observe the comprehensive manual.
NOTE
This quick guide will assist you in handling the device. This quick guide does not replace the description in
the comprehensive manual under
2
Safety
The quick guide that is provided is a constituent part of the device.
F Read and observe the quick guide and keep it accessible at all times.
2.1
Intended use
The device is a transformerless PV inverter which converts the direct current of the PV generator into grid-compatible
three-phase alternating current and then feeds the three-phase alternating current into the public power grid.
The device is built using state-of-the-art technology and in accordance with the recognized safety rules. Nevertheless,
improper use may cause lethal hazards for the operator or third parties, or may result in damage to the product and
other property.
The device is intended for indoor and outdoor applications and may only be used in countries for which it has been ap-
proved or for which it has been released by KACO new energy and the grid operator.
Operate the device only with a permanent connection to the public power grid. The country and grid type selection
must be commensurate with the respective location and grid type.
The requirements of the grid operator must be met for grid connection to take place. The permission of the relevant
authorities may also be required in order to secure authorisation to connect to the grid.
The name plate must be permanently attached to the product and must be in legible condition.
2.2
Improper use of the product
Any other or additional use is not considered proper or intended use and can lead to an annulment of the product
guarantee. This includes:
Use of a distribution system that is not described (grid type)
Use of sources other than PV-strings.
Mobile use
Use in rooms where there is a risk of explosion
Use in direct sunlight, rain or a storm or other harsh environmental conditions
Use in an outdoor area that does not meet the environmental conditions set down in Technical Data/Environ-
mental Data in the comprehensive manual
Operation outside the specification intended by the manufacturer
Overvoltage on the DC connection of over 1,100 V
Device modification
Standalone mode
2.3
Warnings on the device
A warning sticker is affixed to the device, see the figure on the title page.
1 Read the warnings carefully
2 Do not remove the warning sticker.
3 If the warning sticker is missing or illegible, contact a KACO representative or dealer.
Article number: 3016164
2.4
Personnel qualification
The operator may only monitor the LEDs, carry out visual checks and clean the housing of the device. All other work
may only be carried out by a qualified electrician, see the comprehensive manual under
de/downloads
Qualifications that the electrician must have:
Education concerning the installation and start-up of electrical devices and systems.
1
WARNING! The device is not intended for use in residential areas and cannot ensure adequate protection of
radio reception in such environments.
KACO blueplanet 100 NX3 KACO blueplanet 125 NX3
www.kaco-newenergy.com/de/downloads
1
www.kaco-newenergy.com/
Page 3