Kaco blueplanet 100 NX3 Manual Del Usuario página 6

WARNING
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seri-
ously injured.
› Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are
only to be used for masonry and concrete.
› Only install the device in an upright hanging position.
› See the corresponding drawing in chapter 10.5.
Use the leaflet as a drilling template
↻ Have adhesive strips to hand (not in scope of supply).
1 Open the leaflet at the lower right-hand corner and smooth out the marked in-
ner side.
2 Raise the leaflet to the installation location and fix it with adhesive strips at all
four corners.
3 If necessary, adjust the position and height according to and smooth out the
leaflet so that the hole pattern is precisely adhered to. (tolerance: 1mm!)
4 Choose a drill bit and drill all the fixing holes to match the holes in the leaflet.
5 Once the wall plugs are in place, the leaflet can be removed and placed back in
the packaging.
» The device is ready for wall mounting.
4 Installation
4.1 Opening the device
↻ The device has been installed on the mount.
↻ Wipe any moisture off the frame of the housing cover using a cloth.
F Undo the 14 screws (2) and carefully remove the housing cover (1) [
F Take care not to damage or soil the seals and fibre optics when setting down
the housing cover.
» Proceed with the installation of the device.
4.2 Connecting the device to the power grid
4.2.1 Preparing the grid connection
Page 6
1 3
5
2 4
6
Fig. 2: Using the drilling template
1 Leaflet with drill holes
2 Drawing pen (optional)
3 Adhesive strips
T_30]
Fig. 3: Removing the housing
cover
1 Housing cover
2 Fastening screws
KACO blueplanet 100 NX3 KACO blueplanet 125 NX3
Open leaflet
& Strech to fullsize!
1
2
3
7
4
8
1
2