Programme Overview - Amann Girrbach Ceramill Therm Instrucciones De Servicio

gB
Inserting the base plate
Carefully insert the ceramic plate supplied into
the furnace chamber with the smooth side up.
OPeratIOn/hanDlIng
After connection to the mains power, the network
control switch ! will glow continuously.
Only after the control switch has been activated
is the Ceramill Therm connected to the current
control circuit; in doing so, the controller auto-
matically conducts a lamp test (lamp test see
general instructions).
Feeding the ceramill therm with zirconium
frameworks
See the training documents relating to the
Ceramill System and the instruction manual for
Ceramill ZI zirconium blanks.
PrOgraMMe OVerVIew
The Ceramill Therm exhibits 3 programme
locations for sintering Ceramill ZI frameworks
of different indications as well as a freely pro-
grammable programme location for sintering
dental oxide ceramics of other manufacturers
(follow the instructions of the manufacturer!).
Programme description
_ Programme 1
standard programme for ceramill ZI.
T
1450 °C
200 °C
Universal sintering programme for all
common indications.
18
2 h
8°/min
_ Programme 2
Fast sintering programme for ceramill ZI
single units.
T
1450 °C
200 °C
Fast sintering programme for single units only.
The furnace may be charged with max. one
sintering bowl; otherwise, full sintering of the
objects cannot be achieved.
_ Programme 3
sintering programme with extended cooling
period for ceramill ZI.
T
1450 °C
900 °C
200 °C
Sintering programme with hold stage at 900 °C
and defined cooling rate. Especially for large
and massive frameworks, where the connected
residual blank is sintered together with the
framework.
ca. 10 h
t
1 h
12°/min
ca. 6 h
2 h
5°/min
30 min
8°/min
t
ca. 12 h
t