Amann Girrbach Ceramill Therm Instrucciones De Servicio página 23

Programme repetition. Here: 0 repetitions
(default setting)
End temperature at which the furnace may be
opened. Here: 200 °C (default setting)
_ By using the Menu key % , the respective
programme parameters may be viewed in one
direction only; they cannot be changed.
_ At the end of the parameter sequence, the
standby mode is automatically displayed again.
PrOgraMMIng the cOntrOller
(PrOgraMMe lOcatIOn 4)
setting the controller from user mode (OP.b.)
to programming mode (OP.P)
After the furnace has been switched on
Standby „ready"
Hold both keys simultaneously for approx. 3
seconds.
- Press the key until OP.P appears.
gB
23