ENGLISH
Note
Take the robot vacuum cleaner to the charging base if the battery is low. The robot vacuum
-
cleaner may not turn on if battery is too low.
The robot vacuum cleaner will automatically turn on when placed on the charging base.
-
The robot vacuum cleaner cannot be turned off during recharge.
-
Installing the mixed tank. Fig. 10
Open the water-tank silicone lid and carefully fill up the tank while avoiding spillages.
-
Make sure the lid is properly closed. Never immerse the tank in water or other liquids.
Install the mop on the mop bracket.
-
To install the tank on the robot vacuum cleaner, follow the direction shown in figure 10 and
-
manually press the tab and push it into the correct position. You will hear a click when it is
properly fixed.
Install the mop bracket following the direction shown in figure 10.
-
Recommendations
It is not suggested to use the scrubbing function for first-time use.
-
-
Do not use the mopping function if the robot vacuum cleaner is not being supervised.
To remove the mop bracket, press the release button and pull from it outwards.
-
-
Uninstall the mop bracket when the robot vacuum cleaner is charging or when not in use.
-
Add a few drops of cleaning agent to the water if necessary, as long as it is non-corrosive.
Using cleaning agents in excess might block water outlets.
-
-
In order to achieve perfect scrubbing, it is suggested to moisten the mop before using it.
First use
-
Once the robot vacuum cleaner and the charging base are installed, follow these steps
before the first cleaning.
First of all, fully charge the robot vacuum cleaner. It is suggested to allow the robot to
-
charge overnight. Once fully charged, it may carry out the first cleaning cycle and save
the first map. To do so, activate the Auto mode and select the Eco suction level. It is very
important to follow these instructions so that the robot vacuum cleaner recognises every
corner of your house and can carry out a complete mapping of it.
If your house is very large and the robot vacuum cleaner runs out of battery, it will return
-
to the charging base, save both complete and incomplete maps, and, once charged, it will
resume cleaning where it left off until the entire surface has been mapped. The robot
vacuum cleaner is constantly mapping, so it adapts in an individualised and personalised
way to the particularities of each house while constantly improving its map.
54
CONGA 7490 IMMORTAL X-TREME