Descargar Imprimir esta página

Truma S 3004 Instrucciones De Uso página 22

Ocultar thumbs Ver también para S 3004:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 49
Auto ignitor battery change
– If no ignition spark is heard during start-up or if fewer than
two ignition sparks are visible per second, the battery must
be replaced.
– Insert a new battery at beginning of every heating season.
Always use temperature-resistant (+70 °C), leakproof 1.5 V
Mignon batteries (LR 6, AA, AM 3) (part no. 30030-99200),
as other batteries could cause malfunctions.
Possible burn injury hazard if contact is made with the
hot heater. Always ensure that heater is switched off
and has cooled down before replacing batteries.
– Remove the cover.
– Slide the battery compartment cover upwards and replace
the battery. Pay attention to positive / negative.
– Close battery compartment again.
– Re-attach the cover.
Figure 8
Battery disposal
The battery may not be disposed of with domestic refuse,
instead it must be sent for recycling via a collection point.
By doing this you are contributing towards reuse and
recycling.
Special information
If the vehicle floor is coated with underfloor protection, all
heater parts located beneath the vehicle must be covered
so that the resulting spray mist does not cause heater sys-
tem malfunctions. Remove covers again when the work is
complete.
Disposal
Dispose of the appliance and battery in the auto ignitor sepa-
rately in accordance with the administrative regulations of the
relevant country of use. National regulations and laws (in Ger-
many, for example, the End-of-Life Vehicle Regulation) must
be observed.
In other countries, the relevant regulations must be observed.
8
Technical data
(determined in accordance with EN 624 or Truma test conditions)
S 3004 / S 5004
Gas type
Liquefied gas (propane / butane)
Operating pressure
30 mbar (see type plate)
Rated heat output
S 3004: 3500 W
S 5004: 6000 W
Gas consumption
S 3004: 30 – 280 g/h
S 5004: 60 – 480 g/h
Additional information in accordance with EN 624
S 3004: Q
= 4.0 kW (Hs); 290 g/h; C
n
S 5004: Q
= 6.8 kW (Hs); 490 g/h; C
n
Appliance
Destination countries
category
I
AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI,
3B/P(30)
FR, GB, GR, HR, HU, IE, IS, IT, LI, LT, LU,
LV, MT, NL, NO, PL, PT, RO, SE, SI, SK, TR
I
BE, CH, CZ, ES, FR, GB, GR, IE, IT, PT, SI
3+(28-30/37)
Operating voltage
1.5 V (auto ignitor with battery operation)
Power consumption
225 mW (ignition)
Weight
S 3004: approx. 10.3 kg (without fan)
S 5004: approx. 17.5 kg (without fan)
S 3004:
S 5004:
Subject to technical changes.
51
51

Publicidad

loading

Este manual también es adecuado para:

S 5004