AIRROBO P20 Manual De Usuario página 6

Done
EN
5. Added successfully! 6. Now you can operate
Click [Done] to enter the robot through the
next step. AIRROBO APP.
3.4 Operation
① Auto Cleaning
Once activated, the robot will plan the cleaning route in a zigzag pattern, and finish
cleaning by cleaning along rooms' edge. When the cleaning is complete, it will
automatically return to the charging base to charge.
② Spot cleaning
Use the remote control to place the robot or manually place it in a corner of the area to
be cleaned. Tap the Spot button in the App or press the Spot cleaning button
remote control to active this mode, then it will start cleaning this area from current
placement, in zigzag route.
③ Spiral cleaning
Use the remote control to place the robot or manually place it in the center of the area to
be cleaned. Tap the Spiral button in the App or press the Spiral cleaning button
remote control to active this mode, then it will start cleaning this area from current
placement, in spiral route.
④ Edge cleaning
Once activated, the robot will find the wall and clean along the wall automatically. When
the cleaning is complete, it will return to the charging base to charge.
Tips:
1. Due to the update of Airrobo App, the
actual use may be slightly different from
the above. Please follow the current
in-app guides while using.
2. If your device is unable to be found or if
you are prompted with a configuration
timeout after pairing for several times,
please do as follows before trying again.
Resetting Wi-Fi connection on your
device: press and hold [ ] + [ ] for 3
seconds before turning on, turning off
and trying again.Clearing App cache:
Me ‒ Settings ‒ Clear Cache
3. The App is currently not compatible with
Android tablets and iPads.
4. To use the App properly, please turn on
Basic Google Services if you are using an
Android phone.
on the
on the
⑤ Scheduled cleaning
Tap the Settings button in the app, set a cleaning time, then the robot will start to clean at
the specified time. When the cleaning is complete, it will go back to the charging base to
charge.
⑥ Reset Wi-Fi
When you need to connect the robot with other mobile phone, or when the mobile
phone fails to connect to it, you need to reset the Wi-Fi. Press and hold both of the
Clean button and the Home button
hold the Reset Wi-Fi button
the voice prompt. The Clean button
indicating that the Wi-Fi has successfully been reset. Return to the main interface in
the App and click Add to connect the robot.
⑦ Suction level
Tap the Suction Level button on the remote control or in the app, then you can select
among Quiet, Standard, and Powerful.
Part 4 Cleaning and Maintenance
4.1 Cleaning the side brushes
Clean the side brushes and replace them if they are damaged.
Notes: Before replacing the side brushes, check the
brushes and make sure they match the corresponding marking at the bottom of the
robot.
4.2 Cleaning the main brush
• Turn off the robot. Press the two tabs on the main brush cover to remove the cover
and then remove the main brush on the right. Use the cleaning brush to remove hair
and other dirt from the main brush.
• Rinse the main brush under running water and do not replace it until it is dried
completely.
Main brush cover
Main brush
- 5 -
6
on the robot for 3 seconds, or press and
on the remote control for 3 seconds until you hear
on the robot will flash rapidly in orange,
L & R marked on the two side
Unlocking button for the dustbin