Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Press the power icon to cancel the programme and then switch on the appliance again.
-
You can change the programme to the desired cycle setting (see section "Starting a wash
cycle").
NOTE (depending on the model):
if you open the door during a wash cycle, the appliance stops and the warning alarm
-
sounds, then the display shows E1. After closing the door, the appliance will continue to
operate after 10 seconds.
NOTE: if all lights start flashing, indicating that the machine is malfunctioning, disconnect
-
the main power and water supply before calling the official Cecotec Technical Support
Service.
Introducing tableware during the cycle
You can add tableware at any time before the detergent dispenser is activated.
-
Open the door slightly to stop the dishwasher.
-
When the spray arms have stopped, you can open it completely.
-
Insert the forgotten dishes.
-
Close the door. The dishwasher will operate after ten seconds.
-
WARNING!
It is dangerous to open the door while a wash cycle is running, as the hot water may cause
burns.
Switching off the dishwasher
The digital display shows "---" and the machine beeps 6 times; only in this case the
-
programme is finished.
Switch off the dishwasher by pressing the power icon.
-
Cut off the general water supply.
-
Open the door carefully. When opening the door, steam may come out.
-
Hot dishes are sensitive to shocks. Therefore, you should let the dishes cool down for 15
-
minutes before removing it from the appliance.
Open the dishwasher door, leave it ajar and wait some minutes before removing the
-
dishes. This way, it will be cooler, and the drying will be better.
Unloading the dishwasher
It is normal for the dishwasher to be damp inside.
-
First empty the lower basket and then the upper one. This will prevent water from the upper
basket from dripping onto the dishes in the lower basket.
BOLERO AGUAZERO 4101 FULL-BI E
94
Publicidad
