Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
3.
Using a stud finder or equivalent tool, locate at least 1 wall stud and mark its
positions on the wall. While holding the support bar in its position against the
wall, check that it is level, then mark 3 positions for 3 holes as indicated. One of
the holes must be right over the wall stud.
4.
Keep the support bar in the position, then drill pilot holes on the wall
through the support bar at the marked positions using ø1/8" (2.5mm) drill bit
as illustrated.
5.
Except for the hole that is over the stud,
wall using ø5/16" (8mm) drill bit and
using a rubber mallet until the wall anchors are flush with the wall.
drill in the exisiting holes on the
insert the wall anchors (AA) into the holes
3
4
5
ø1/8"
2.5mm
ø5/16"
8mm
AA
PAGE 7
Publicidad
