Publicidad
Idiomas disponibles
Idiomas disponibles
Finally, remove the bottom cover. To do this, place the trimmer (A) part parallel to a at surface, rotate the two positio-
1 1
ners 90° and pull them towards the outside to remove them.
Clean the blade (top and bottom sections), the main trimmer part (rear) (A) and the hopper (C) with hot water
1 2
under pressure using a water jet pressure washer. Wash the barrel with hot water. Never apply pressure to it as this
could damage it (do not use the pressure washer). Then disinfect all the parts mentioned and the command
component with Master Clean (D) (THE ELECTRICAL MODULE MUST NOT BE CLEANED WITH WATER UNDER ANY
CIRCUMSTANCES). To clean the leaf collector (B), take out the leaf leaves or other residues using gloves. Wash the
bag (G) with hot water. Ensure that the turbine the entry and outlet port are always clean to prevent any obstruc-
tions.
CLEAN WITH WATER UNDER PRESSURE AND
MASTER CLEAN (D) FOR DISINFECTION.
Reassembly
Reinsert the lower cover. Rotate the positioners 90°
1
and ensure they are well placed.
90°
22
90 °
DO NOT CLEAN BY APPLYING PRESSURE
90°
90 °
X
Insert the blade. Put it in place and turn the
2
two positioners 90° for your safety. It's very
important to ensure that the blade is correct-
ly anchored and is held rmly.
90°
90°
Publicidad
