Publicidad
Idiomas disponibles
Idiomas disponibles
Changing injectors
Hob burners
•
Cut off the main gas supply and unplug
the appliance from the mains electrical
supply.
•
Remove the burner caps and the
adapters.
•
Use a 7 mm spanner to unscrew the
injectors.
•
Replace the injector with the ones from
the gas conversion kit, with the correct
diameters for the type of gas that is
going to be used, according to the gas
injector table.
Burner
cap
Adapter
Cup
Spanner
Adapter
Oven/Grill (if available) Injectors
To replace the oven injector, open the oven
door. Remove the screws which hold the
burner cover in position and remove the
burner cover. Remove the screws which
hold the burner to the underside of the inner
case and turn the burner carefully towards
you. Remove the oven back panel and the
oven injector is visible and can be replaced
using a 7 mm spanner.
To replace the grill injector, open the oven
door and remove the screws which hold
the grill burner to the top of the inner case.
Pull the grill burner carefully towards you.
The grill injector will be visible from the side
where the burners can be disassembled.
Screw
Remove the injectors using a 7mm
spanner and replace the injector with the
ones from the spare set. Make sure you
use corresponding diameters suitable to
the type of gas that is going to be used,
according to the information chart (which is
also supplied in the gas conversion kit).
After conversion is completed, check for
any gas leakage.
Adjusting the minimum flame position
First of all, make sure that the appliance
is unplugged from the mains electrical
EN - 15
Injector
Publicidad
