Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not use adaptors, multiple sockets
and/or extension leads.
•
The supply cord should be kept away
from hot parts of the appliance and must
not be bent or compressed. Otherwise
the cord may be damaged, causing a
short circuit.
•
If the appliance is not connected
to the mains with a plug, a all-pole
disconnector (with at least 3 mm contact
spacing) must be used in order to meet
the safety regulations.
•
The appliance is designed for a power
supply of 220-240 V~. If your supply is
different, contact the authorized service
personnel or qualified electrician.
•
The power cable (H05VV-F) must be
long enough to be connected to the
appliance.
•
The fused switch must be easily
accessible once the appliance has been
installed.
•
Ensure all connections are adequately
tightened.
•
Fix the supply cable in the cable clamp
and then close the cover.
•
The terminal box connection is placed
on the terminal box.
Brown
2.6 anti-tiltinG kit
1
Anti-tilting
Bracket
(x1) (will be
attached to the
wall)
The document bag contains an
anti-tilting kit. Loosely attach the anti-
Blue
Yellow+Green
2
Screw (x1)
3
wall
plug (x1)
tilting bracket (1) to the wall using the
screw (2) and wall plug (3), following the
measurements shown in the figure and
table below. Adjust the height of the anti-
tilting bracket so that it lines up with the slot
on the cooker and tighten the screw. Push
the appliance towards the wall making sure
that the anti-tilting bracket is inserted into
the slot on the rear of the appliance.
A
Product Dimensions
(Width X Depth X Height) (Cm)
60x60x90 (Double Oven)
50x60x90 (Double Oven)
90x60x85
60x60x90
60x60x85
50x60x90
50x60x85
50x50x90
50x50x85
2.7 aDjuStinG the feet
The appliance is supplied with 4 adjustable
feet. Attach the feet to the bottom panel
support by rotating clockwise as shown in
the figure.
For safe operation, it is important that your
appliance is correctly balanced. Make sure
the appliance is level prior to cooking. To
increase the height of the appliance, turn
the inner part of the feet anti-clockwise. To
decrease the height of the appliance, turn
the inner part of the feet clockwise.
It is possible to raise the height of the
appliance up to 50 mm by adjusting the
feet. The appliance is heavy and we
recommend that a minimum of 2 people lift
it. Never drag the appliance.
EN - 17
Wall
Anti-
tilting
bracket
B
A (mm)
297.5
247.5
430
309.5
309.5
247.5
247.5
247.5
247.5
B (mm)
52
52
107
112
64
112
64
112
64
Publicidad
