Lavorwash SW 2600 BT Manual De Instrucciones página 41

THE DESTRUCTION OR DEMOLITION OF THE MACHINE MUST BE CARRIED OUT BY THE
OWNER WITH TOTAL OBSERVATION OF THE LAWS IN FORCE. IT IS ADVISABLE TO
UTILISE COMPANIES SPECIALISED IN THIS SECTOR.
In any kind of emergency situation such as, for example, if You have accidentally driven the sweeper over
current-carrying cables on the floor which have wound around the main or side broom, or there are strange
noises coming from inside the machine or motor, or You have accidentally picked up incandescent materials or
flammable liquids, chemical products in general, poisons, etc.
YOU WILL HAVE TO:
1 - Release the lever to stop traction.
2 - Turn engine off in the explosion engine models, putting the accelerator lever, that is on the
engine, onto STOP; or in the case of battery powered sweepers, turn the start key, on the control
panel, from right to left.
3 - If You have collected any of the material described above, extract the container (bin)
it wearing gloves and a mask to protect Your lungs. In all events, please follow the instructions
given on the paragraph Collection container.
Two main faults may occur in the sweepers: the machine causes dust during use or leaves dirt on the floor;
there can be many reasons for this but if the machine is used correctly and routine maintenance is carried out
regulary, they should not occur very often. Therefore:
THE MACHINE CAUSES DUST
THE MACHINE LEAVES TRACES OF
DIRT ON THE FLOOR
THE EXPLOSION ENGINE IS NOT
PERFORMING CORRECLTY
THE BATTERY-POWERED SWEEPER
IS NOT PERFORMING CORRECTLY;
IT IS SLOW AND IS NOT
CLEANING WELL
This machine is guaranteed against defects in workmanship or installation for 12months from the date of sale.
FAULTS
LEVER IN POSITION TO STOP
SUCTION
FILTERS CLOGGED
FILTER DAMAGED
FILTER BADLY INSTELLED
SIDE DUST FLAP(S) DAMAGED
CONTINUOUS USE OF THE SIDE
BROOM
THE MAIN BROOM IS NOT
CORRECTLY ADJUSTED OR IS
WORN
YOU HAVE COLLECTED WIRES,
CABLES ETC.
SIDE FLAP(S) DAMAGED
THE COLLECTION BIN IS FULL
ENGINE AIR FILTER IS DIRTY
CARBURATION WRONG
FLAT BATTERY OR NOT FULLY
CHARGED
THE RECOMMENDED BATTERY
CHARGER HAS NOT BEEN USED
CHAPTER 17 – EMERGENCY SITUATIONS
CHAPTER 18 – FAULTS / CAUSES / REMEDIES
CAUSE
S
PUSH THE KNOB TO OPEN THE
SUCTION
CLEAN THEM BY SHAKING IT WITH
THE FILTER-SHAKER AND IF
NECESSARY REMOVE AND CLEAN
IT THOROUGHTLY
REPLACE IT
MAKE SURE IS CORRECTLY
INSERTED
REPLACE IT (THEM)
USE THE SIDE BROOM ONLY FOR
THE EDGES, BORDERS AND
CORNERS
CHECK THE MAIN BROOM AND IT
"TRACK"
REMOVE THEM
REPLACE IT (THEM)
EMPTY IT
CLEAN OR REPLACE IT
RECARBURATE
CHECK THE LEVER OF THE
ELECTROLYTE AND CARRY OUT A
NEW COMPLETE BATTERY
CHARGING CYCLE
USE AN APPROPRIATE BATTERY
CHARGER
Pag. 41
REMEDIE
S
CHAPTER 19 - WARRANTY
and clean