Descargar Imprimir esta página

Vacmaster VJH1211PF 1101 Manual Del Usuario página 10

Aspiradora en mojado/seco

Publicidad

Idiomas disponibles

Idiomas disponibles

DRY VACUUM OPERATION
1
2
7
8
DRY VACUUMING
WARNING:
ENTITLED 'IMPORTANT SAFETY INSTRUCTIONS'. DO NOT VACUUM IN AREAS WITH
FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUST IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID,
SOLVENT TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR
AEROSOL SPRAYS. EXPLOSIVE DUST INCLUDE BUT ARE NOT LIMITED TO: COAL,
MAGNESIUM, GRAIN, OR GUN POWDER. TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
CAUTION:
WITH STANDARD WET/DRY FILTER. THIS IS A VERY FINE DUST WHICH WILL NOT
BE CAPTURED BY THE FILTER AND MAY CAUSE DAMAGE TO MOTOR. WHEN
VACUUMING FINE DUST USE A FINE DUST FILTER (INCLUDED). TO PURCHASE
ADDITIONAL FINE DUST FILTERS, CALL 1-866-384-8432 OR GET THEM AT YOUR
LOCAL OR ONLINE VACMASTER
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. In order to prepare your vacuum for dry vacuuming, make sure the cartridge filter completely
covers the filter cage against the powerhead. Your wet/dry vacuum comes with the cartridge
filter pre-installed. For installation instructions, see page 14 (Fig. 2).
3. Place filter retainer on the top of cartridge filter and tighten down by turning the retainer handle
clockwise (Fig. 3).
4. Place the powerhead back on the collection tank and secure it in place using the latches (Fig. 4).
OPERATING INSTRUCTIONS: DRY VACUUMING
5. Insert the locking end of the hose into the vacuum port on the collection tank and turn clockwise
to lock into place (Fig. 5).
6. Choose the desired accessory and insert onto the free end of the hose or extension wand
(Fig. 6).
7. Verify that the switch is in the 'O' OFF position before plugging the power cord into the outlet.
Plug the power cord into the outlet (Fig. 7).
8. Turn the vacuum on by flipping the switch to the 'I' ON position and begin vacuuming (Fig. 8).
3
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
DO NOT VACUUM DRYWALL DUST, FIREPLACE SOOT, OR ASH
4
®
RETAILER.
9
5
6

Publicidad

loading