Amana Easy Touch Control 500 Guía De Uso Y Cuidado página 7

@
Cooktop
To prevent the cooktop from discoloring or
staining:
"Cban cooktop after each use.
Wipe acidic or sugary' spins as soon as the cooktop has
coobd as these spins may discobr the
:_ _ porcelain.
_ Unlike a range with standard gas burners,
__ this cooktop does not lift-up nor is it
removable. Do i?ot attempt to lift the
cooktop for any reason.
Burner Grates
The grates must be properiy positioned before cookhlg.
When h)stdling the grates, place the tab ends toward the
center, matching the straight bars.
hnproper installation of the grates may result in chipping of
the cooktop.
Sea ed Burners
The sealed burners of your range are secured to the cooktop
and are not designed to be removed. Since the burners are
sealed into the cooktop, boilovers or spills will not seep
underneath the cooktop.
However, the burner should be cleaned after each use. The
head portion of the burner is easily removed for cbaning.
(See page 17 for cbaning directions{)
The burner heads must be correctly placed on the burner
base for proper operation of the burner.
Do not operate the burners without a pan on the grate.
The grate's porcelain finish may chip without a pan to
absorb the heat from the burner flame.
Use care when stirring food in a pot/pan sitting on the burner
grate. The grates have a smooth finish for ease of cleaning.
The pot/pan will slide if the handle is not held. This may result
in spilling of hot food items and may be a burn hazard.
Although the burner grates are durable, they will gradually
lose their shine and/or discolor, due to the high temperatures
of the gas flame.
Nigh Performance Burner
(12,000 BTU*}
There is one high speed burner on your range, located in the
right front position. This burner offers higher speed cooking
that can be used to quickly bring water to a boil and for large-
quantity cooking.
Simmer Burr|or
This burner is located in the left rear position. The simmer
burner offers a lower BTU* flame for delicate sauces or
melting chocolate.
BTU ratings wiii vary when using LP gas.
" A properly adjusted burner with clean ports wiii light
within a few seconds. If using natural gas, the flame
wiii be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy, the air/gas
mixture may be incorrect. Contact a service technician
to adjust. (Adjustments are not covered by the war-
ranty.}
With LP gas, slight yellow tips on the flames are
acceptable. This is normal and adjustment is not
necessary'.
" With some types of gas, you may hear a "popping"
sound when the surface burner is turned off. This is a
normal operating sound of the burner.
" If the control knob is turned very' quickly from Nigh to
Low, the flame may go out, particularly if the burner is
cold. If this occurs, turn the knob to the OFF position,
wait several seconds and relight the burner.
" The flame should be adjusted so it does not extend
beyond the edge of the pan.
6