Publicidad
Idiomas disponibles
Idiomas disponibles
• Slide new belt over the drive and idler drums; center belt
on drums.
• Additional abrasive belts are available (See Recommended
Accessories,
page 15).
• Push tension lever towards drive drum to tension belt.
• Check tracking. See "Adjusting Belt Tracking", page 6.
Replace cover and wing nuts.
Wing Nuts
Figure 17 -Remove Wing Nuts and Cover
REPLACING
ABRASIVE
DISC
Refer to Figure 18.
• Remove table assembly.
• Remove disc cover by loosening and removing five screws.
• Remove old abrasive disc by peeling it from the aluminum
disc. Removing aluminum disc is not necessary.
• Clean aluminum disc if necessary. Select the desired abra-
sive disc and apply to aluminum disc.
• Additional abrasive discs are available (See
Recommended
Accessories,
page 15).
• Replace disc cover.
WARNING:
Make certain that the unit is disconnected
from
power source before attempting to service or remove any
component.
CLEANING
Keep machine and workshop clean. Do not allow sawdust to
accumulate on the tool. Keep the drums clean. Dirt on drums
will cause poor tracking and belt slippage. Periodically empty
the dust collection bag.
Be certain motor is kept clean and is frequently vacuumed
free of dust.
Use soap and water to clean painted parts, rubber parts and
plastic guards.
LUBRICATION
The shielded ball bearings in this tool are permanently
lubricated at the factory. They require no further lubrication.
• When operation seems stiff, a light coat of paste wax
applied to the belt table and disc table will make it easier to
feed the work while finishing.
• Do not apply wax to the belt platen. Belt could pick up wax
and deposit it on wheels causing belt to slip.
KEEP TOOL
IN REPAIR
• If power cord is worn, cut, or damaged in any way, have it
replaced immediately.
• Replace worn abrasives when needed.
• Replace any damaged or missing parts. Use parts list to
order parts.
Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician. Repair
service is available at your nearest Sears store.
Figure 18 - Removing Disc Cover
Publicidad
