Leica SL3 Instrucciones Abreviadas página 22

REGULATORY INFORMATION
Specific regional approvals for this device can be found in the camera menu.
▸ Select
Camera Information
▸ Select
Regulatory information
Alternating current
(AC)
Direct current (DC)
DISPOSAL OF ELECTRICAL AND ELECTRONIC EQUIPMENT
(Applies within the EU and for other European countries with active waste separation policies.)
This device contains electrical and/or electronic components which must not be disposed of in general house-
hold waste. Instead, it should be disposed of at a recycling collection point provided by your local authority.
This service is free of charge. Any standard or rechargeable batteries used in this device must be removed and
disposed of separately in accordance with local regulations. Please contact your local authorities, waste disposal
collection point or the retailer, from whom you purchased the device for more information on correct waste
disposal.
CE MARK
Declaration of Conformity (DoC)
"Leica Camera AG" hereby declares that this product is in compliance with the
basic requirements and other relevant provisions of Directive 2014/53/EU.
Customers can download a copy of the original DoC for our Radio Equipment
products from our DoC server:
www.cert.leica-camera.com
Please contact Leica Camera AG, Am Leitz-Park 5, 35578 Wetzlar, Germany in
case of any further questions
Usable frequency band / restrictions fo r use: see technical data
Maximum output (e.i.r.p.): WLAN: < 20dBm / Bluetooth: < 10dBm
Leica SL3 comes with splash water and dust protection.
The camera was tested under controlled laboratory conditions and is classes as IP54 in accordance with DIN
EN 60529. Please note: The splash water and dust protection coating is not permanent and will diminish over
time. The user manual contains instructions on how to clean and dry the camera. The warranty does not cover
liquid damage. Any attempt to open the camera casing by an unauthorized retailer or service partner will
cause an immediate expiration of the splash water and dust warranty.
The switching adapter output when charging the
camera battery depends on its operating mode. A
min. switching adapter output of 2.5 W is required
when the camera is switched off.
An output of min. 27 W is required if the camera is
2,5/27 W
switched on.
USB PD
USB-PD capable
in the main menu
Class II devices (the product has a double-insulated design)
The CE mark on our products documents com-
pliance with the fundamental requirements of
applicable EU guidelines.
Use of the Made for Apple badge means that an accessory
has been designed to connect specifically to the Apple pro-
duct(s) identified in the badge and has been certified by the
developer to meet Apple performance standards. Apple is
not responsible for the operation of this device or its compli-
ance with safety and regulatory standards. Please note that
the use of this accessory with an Apple product may affect
wireless performance. Apple®, Apple TV®, Apple Watch®,
iPad®, iPad Air®, iPad Pro®, iPhone®, and Lightning® are
trademarks of Apple Inc., registered in the U.S. and other
countries. tvOS® is a trademark of Apple Inc.