Publicidad
Idiomas disponibles
Idiomas disponibles
ACOUSTIC POWER LEVEL (dB) IN
"COOLING" MODE L
PLANETARY WARMING POTENTIAL, PRP
Leaking refrigerants accentuate climate change. In the event of a leak, the impact on global warming
will be all the more limited as the global warming potential (GWP) of the refrigerant is low. This device
uses a refrigerant with a GWP equal to 3. In other words, if 1 kg of this refrigerant is released into the
atmosphere, its impact on global warming will be 3 times greater than that of 1 kg. of CO2, over a
period of 100 years. Never attempt to intervene in the refrigeration circuit and to disassemble the parts
yourself and always contact a professional.
ELECTRICITY CONSUMPTION IN "THERMOSTAT OFF"
MODE (W), P
POWER CONSUMPTION IN "STANDBY" MODE (W) P
For any further information, please contact: Schneider consumer
group, 12 rue Jules Ferry, 93110 Rosny-sous-bois, France
REPAIR :
Problem
Does not work.
Works only for a few
moments.
Works, but does not
cool.
Does not work and the
alarm light comes on.
The display shows Ft,
E0, E1 or E2.
Dehumidification
does not work.
WA
REFRIGERANT
(kgCO
eq)
2
TO
To analyse
• The circuit breaker or fuse is blown.
•
Wait 3 minutes, then turn the device back on.
• The batteries in the remote control are exhausted.
• The plug is not plugged in correctly.
• Requires use of the device in an ambient temperature of
5 °C to 35 °C.
• If the set temperature is close to room temperature.
• Air outlet blocked by an obstacle. Remove this obstacle.
• Door or window.
• Another heater is working (heater, lamp, etc.).
• The air filter is dirty. Clean it up.
• Clogged air outlet or intake.
• The hot air exhaust pipe is correctly installed.
• Drain the water into a container using the drain hose on
the back of the appliance. If it still does not work, consult a
qualified technician.
• Ft means that the water tank is full, it must be emptied.
• E0 means a communication fault between the main PCB and
the display PCB. Contact the after-sales service.
• E1 means that the room temperature sensor is
defective. Contact the after-sales service.
• E2 means that the pipe temperature sensor is defective.
Contact the after-sales service.
•
Requires
use of the device in an ambient temperature of
over 15 °C.
SB
EN-25
65
R290 (0.17 kg)
3
-
0.5
Publicidad
