Tools - LEMAN RAD310-RAD310T Manual De Instrucciones

TOOLS

Recommended tools
Cutterblocks have to be marked with manufactures name or logo (marking) and max allowed
rotations. Suitable tools for this machine are knives system HSS 250X30X3mm and must meet
the reqirements of EN847-1.
Exchange and adjustment of knives
WARNING! Disconnect the machine from mains before any adjustment.
Swing away the planing tables before exchange of knives.
Release five screws (4) by spanner.
By the force of the spring (1), the knife (2) will be pushed out automatically.
Remove the knife and clean the bearing surface.
Clean the new knife carefully.
Insert the new knife by screwing five screws (4) so that its extension above the surface of
cutterblock in max 1.1mm.
The manufacturer recommends the height of extension from 0.7 to 0.8mm.
Then tighten the pressing off wedge with five screws.
After all the above-mentioned steps are finished make sure to check whether all the five screws
are in proper place and fix all protective covers and then try to start the machine by pushing the
switch "ON" button.
WARNING! Do not use knives with width under 17mm.
Its fixing area is too small.
１３
EN