Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:Use only sockets
designed for impact
wrenches. Always select the
correct size impact socket for
nuts and bolts.
Inserting and Removing Socket
(not supplied)
-Push the socket onto the anvil
until it locks into place.
- To remove the socket, pull it
away from the anvil.
NOTE: Make sure the battery
is removed before changing
accessories.
OPERATION
Trigger Lock
Set the forward/reverse control
switch in the OFF (center lock)
position to lock the trigger and
avoid accidental starting when not
in use.
Forward and Reverse Control
Switch
For forward rotation, set the con-
trol switch to the left of the on/
off trigger.
10
For reverse rotation, set the
control switch to right of the on/
off trigger.
WARNING: Never change
the direction of rotation
when the anvil is rotating, wait
until it has stopped!
To turn the tool ON, depress the
switch trigger. To turn it OFF,
release the switch trigger and
allow the anvil to come to a
complete stop.
Here are four modes. The
corresponding indicator lights
will illuminate under each mode.
The first three modes are used
to adjust the speed, with mode
one being the slowest and mode
three being the fastest. In mode
four, when the tool is running and
reaches a certain status, it will
automatically stop.
20V Brushless High Torque 1/2" Impact Wrench
Operating the On/Off Trigger
because excess heat will be
produced internally.
See Fig. B1,
Using The LED Light
B2
Before operation, the LED light
will be activated when the On/
Off switch is slightly depressed,
and will automatically turn off 20
seconds after the On/Off switch is
released.
The tool and battery are equipped
with a protection system. When
the LED Light is quickly flashing 3
seconds and turn off, the system
will automatically cut off power
to the tool to extend battery life.
The tool will automatically stop
See Fig. C1
during operation if the tool and/
or battery are placed under one of
the following conditions:
• Overloaded: The tool is operated
in a manner that causes it to draw
an abnormally high current. In
this situation, release the Trigger
Switch on the tool and stop the
application that caused the tool to
become overloaded. Then pull the
See Fig. C2,
Trigger Switch again to restart.
C3
• Overheated: Under the condition
above, if the tool does not
start, the Tool and Battery are
overheated. In this situation, let
the Tool and Battery cool before
pulling the Trigger Switch again.
• Low battery voltage: The
remaining Battery capacity is too
low and the tool will not operate.
In this situation, remove and
recharge the Battery.
See Fig. D
On/Off switch and make sure the
Forward/Reverse Rotation Control
is on right/left position.
6.TROUBLE SHOOTING
1. I CAN NOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only in
one direction. Turn the battery around until it can be
inserted into the slot, the red LED Light should turn
on when the battery is charging.
WARNING: Do not operate
for long periods at low speed
WARNING:
To turn on the light, press the
See Fig. E
EN
Publicidad
