Hotpoint 22 Manual Del Propietario Y Instalación página 18

Installation Instructions
INSTALLING THE WATER LINE (CONT.)
[] CONNECT THE TUBING TO THE
VALVE
Place the compression nut and fen-ule (sleeve)
onto the end of the tubing and connect it to the
shutolr valve.
Make sure the tubing is fully inserted into the valve.
Tighten the compression nut securely.
Saddle-Type Shutoff V alve
\
3mpression Nut
Packing Nut
OutletValve
NOTE: Commonwealth of MassachusetLs Plumbing
Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in MassachusetLs.
Consuh with your licensed plumber.
[] FLUSH OUT THE TUBING
Turn the main water supply on and flush out the
tubing until the water is clear.
Shut the water offat the water valve after about
one quart (1 liter) of water has been flushed
through the tubing.
[] CONNECT THE TUBING TO THE
REFRIGERATOR
NOTES:
• Before making the connection
to the refrigerator,
be sure the refrigerator power cord is not plugged
into the wall outlet.
• If your refrigerator does not have a water fitter.
we recommend installing a water fiher if your
water supply has sand or particles that could clog
dae screen of the refrigerator's waler valve. Install
it in the water line near the refrigerator.
[] CONNECT THE TUBING TO THE
REFRIGERATOR (CONT.)
Remove the access cover.
\
Remove the plastic flexible cap fi'om the water valve
(refi'igerator connection).
Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown.
Insert the end of the tubing into the water valve
connection ;usfar as possible. While holding the
tubing, tighten the fitting.
Fasten the tubing into the clamp provided to hold
it in a vertical position. You may need to pIT open
the clamp.
Tubing,_
.\
Ferrule _' [
(sleeve)_
Refrigerator
Connection
Reattach the access cover.
18