Hotpoint 22 Manual Del Propietario Y Instalación página 19

Installation Instructions
INSTALLING THE WATER LINE (CONT.)
[] TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten any connections that leak.
[] PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigeralor or against the
wall. Push the refrigerator back to the wall.
START THE ICEMAKER (ON SOME
MODELS)
Set the icemaker power switch to the ON position.
The icemaker will not begin to operale until it
reaches its operating temperature of 15°F
(-9°C) or below. It will then begin operation
automatically if the icemaker power switch is in
the ON position.
NOTE: In lower water pressure conditions, the
waler valve may turn on up to 3 times to deliver
enough water to the icemaker.
/9