Hotpoint 22 Manual Del Propietario Y Instalación página 25

Performance Data Sheet
Hotpoint SmartWater Filtration System
HWF Cartridge
Health Claim Performance Certified by NSF/ANSI*
'I00% safety factors built in for unmetered usage)
Parameter
Standard No. 42: Aesthetic Effects
Chlorine
F&O
Pardculam** 200,000
Parameter
USEPA
MCL
Turbidity-
OysL
Lead at pH 6.5
Lead at pH 8.5
Lindane
Atrazdne
2,4-D
Asbestos
Iinelnent
Challenge
1.9 ppm
Effluent
Average Maximum
0.02 ppm 0.05 ppm
3,978 7,800
% Reduction
Average Minimmn
98.90% 97.37%
98.00% 96.10%
USEPA
MCL
1 NTU***
99.95% Reduction
15 ppb
15 ppb
0.0002 ppm
0.003 ppm
0.100 ppm
99%
Standard No. 53: Health Effects
In fluent Effluent
Average
0.07 NTU
26
1 ppb
1.8 ppb
0.00005 ppm
0.002 ppm
0.0264 ppm
0.32 MFI/ml
Maximmn
0.1 NTU
55
1 ppb
4.3 ppb
0.00005 ppm
0.003 ppm
0.080 ppm
1.2 MFI Jml
Challenge
24.3 NTU
105,750
160 ppb
150 ppb
0.00062 ppm
0.0084 ppm
0,272 ppm
69() MFI/ml
Average
99.71%
99.97%
99.37%
98.80%
91.93%
76.19%
90.29%
99.95%
* Testedusing a flow rate of 0.5 gpm; pressure of 120psig; pH of Z5-+0,5; t emp. of 20-+2.5 C
** Measurement #7partioles/ml
*** NTU = Nephelometrio Units
% Reduction
Minimmn
99.59%
99.95%
99.37%
97.13%
91.93%
64.28%
70.58%
99.82%
Operating Specifications
_ Capacity-: certified for up to 300 gallons ( 1135 1); up to six mtmths for models without a replacement filter indicator light;
up to one year for models with a replacement filter indicator light
_! Pressure requirement: 40-120 psi (2.8-8.2 bar), non-shock
_VFemperature: 33-100 F (0.6-38 C)
_ Flow rate: 0.5 gpm (1.9 lpm)
General Installation/Operation/Maintenance Requirements
_ Flush new cartridge at full flow for 3 minutes to purge out trapped air.
_ Replace cartridge when flow becomes too slow.
Special Notices
_ Installation inslructions; parts and service availabilily; and standard warranly are included with the product when shipped.
_ This drinking water system must be maintained according to manufacturer's insu'uctions, including replacement of
filter cartridges.
_ Do not use with water that is microbiologically unsafe or of unknown qualily without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts.
_gThe contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.
_ Check for compliance with the state and local laws and regulations.
System Tesmd and Certified by NSF Intcrnalional against ANSI/NSF
Standard 42 & 53 tor the reduction of:
Standard No. 42: Aesthetic Effects
Chemical Unit
Taste and Odor Reduction
Chlorine Reduction, Class l
Mechanical Filtration Unit
Particulate Reduction, Class I
Standard No. 53: Health Effects
Chemical Reduction Unit
Lead and Atrazine Reduction
IJndane and 2,4-D Reduction
Mechanical Filtration Unit
Turbidity Reduction
Cyst and Asbestos Reduction
Manufactured for: General ElectFic Company, I xmisville, KY 40225
25